Recently, many friends reported to our Xiaobian of xinjiejia clothing that they always have a series of problems in the process of processing sweaters. They don't know what problems to pay attention to. As an excellent sweater processing factory, our xinjiejia clothing is naturally to answer your doubts. 1. The main process of knitted sweater is edge binding. It depends on whether the density, width, color and quality of the edge binding are done according to the requirements. 2. Before cutting, it is very important to test the fabric shrinkage and adjust the paper pattern according to the shrinkage. 3. The problem of ironing and shrinking of auxiliary materials. Knitted sweaters sometimes need to be equipped with some auxiliary materials such as webbing and rubber tendons, but the shrinkage of these auxiliary materials is difficult to match with the fabric. At this time, the factory must first require the fabric to be pre shrunk (pre shrunk by the pre shrinking machine), and all kinds of auxiliary materials with shrinkage can be ironed before making. 4. Handcuffed gestures. For example, two trouser legs are usually long and short in factories. In order to reduce the gap between long and short trouser legs, it is necessary to require the hand gesture of the lathe worker. One trouser leg just went up to the crotch, so the lathe worker is required to pull the fabric a little. When changing another trouser leg, he goes to the trouser leg. At this time, he can't pull the fabric, but push the fabric. 5. Post ironing is very important. The phenomena such as long and short sleeves in the processing of knitted sweaters and the pulling deformation of various parts can be adjusted by ironing. It can be said that most knitted sweaters rely on ironing. In fact, these are some common problems in sweater processing. The small knitting of sweater processing factory reminds you that in addition to the above matters that need special attention, other routine matters need to be paid attention to in the processing process.